|
Background: OSM 2012 found it useful to have a similar decision for EN 60065 as the decision 01/8 for EN 60950-1. It has lately been questioned by the chairman of IEC TC108/MT1 that the decision 12/2 may amend EN 60065. Thus, we are proposing a revision of 12/2. Ref. OSM/EE – 2007 Item No.7.1 (enclosed):
$ O) l2 p, G( S; p" u$ G: y+ e“OSM decision 01/8 requires markings on the product (e.g. "Use only power supplies listed in the user manual / user instruction." or “For applicable power supplies see user instruction”). Furthermore such sentences shall be in the languages acceptable to the country where the product will be used.
# k K. n" t9 v& c/ MWe cannot assume that all people speak or understand English and therefore it is necessary to put nearly all languages of such relevant safety instructions on the product.
' }6 \& {( m' D ^% RThat cannot be a solution because many products are too small!”" }: h/ V8 B* S
OSM/EE-2007 agreed to use instead of such instructions (sentences) on the product, international accepted symbols like these both marks (ISO 7000-0434 and ISO 7000-1641):
- m9 ^+ x6 \* M+ k" k" V' F* V" V, ?Later it was confirmed by TC108/MT1 that the book only can be used as an alternative. See explanatory notes below. Based on this it is proposed to revise decision 12/2 as amended with red text under the decision below.
- O) V3 T% j3 H6 C5 Q" eIn case safety of an end apparatus relies upon the power supply for general use (adaptor) to EN 60065 apparatus, the use of the specific adaptor needs to be controlled.# B! W! s/ l! A4 S2 k
The safety issues may relate to a reliable insulation, single fault conditions, heating etc.% M& `; L6 l; P
Extract of 5.4 Instructions:' s. w4 y" y2 Y$ Z
When information with regard to safety is required according to this standard, this information# w* D9 |4 E) Q" H, _: t; u" u
shall be given in an instruction for installation or use and supplied with the apparatus. …, f6 Y0 f7 \# f3 C) r* X
It would be useful to have a similar Decision for 60065 as the Dec 01/8 to EN 60950-1.
4 e# ?$ H) f7 l6 B/ FDec 01/8 is enclosed for convenience.
i) y; @' U8 O( \( J: F# a- B0 ?4 p7 U" F; z4 K+ c5 @1 e& U
Decision: This decision replaces 12/2 with the amended text in red:! C9 ]+ J# l! j" W, f" O: U
When safety of an apparatus relies upon the power supply (adaptor) using a non-special connector for the a.c./d.c. input, the apparatus must have a marking stating the following: "Use only power supplies listed in the user instructions"
6 W5 X( m+ K" j/ Jor; I$ P5 @" [* \- E( E
"For applicable power supplies see user instructions". This statement shall also be in the user-instructions.
1 n. F6 s o g k+ _* B- n( d' DThe user instructions must then have a listing of manufacturers and models of the relevant power supplies. As an alternative to the text on the product, it is acceptable to use both the symbols ISO 7000-0434 and ISO 7000-1641. The book alone is also sufficient (ISO 7000-1641).. ?6 }7 g1 q4 L- ]6 H! |
5 g% t# r1 J. h+ {$ c" L E
|
|