|
本帖最后由 清水白菜 于 2012-9-25 13:58 编辑
- _9 V$ q$ f: R1 ]+ ]6 Y
. t5 ?5 \7 l3 Q7 G9 RIn addition, double and reinforced insulation shall withstand the partial discharge test according to 7.5.3, if the recurring peak working voltage across the insulation is greater than 700 V and the voltage stress on the insulation is greater than 1 kV/mm.
1 P# h5 K! U! j0 Q- ZCompliance is shown by impulse withstand voltage test according to 7.5.1 and the a.c. or d.c. voltage test according to 7.5.2, and partial discharge testing according to 7.5.3 if applicable.
0 u, c, Y I+ C- W! x( p( m k/ K6 o9 Q0 X1 t# G. q9 j
Starting from a voltage below the rated discharge voltage UPD a, the voltage shall be linearly increased to 1,875 times UPD and held for a maximum time of 5 s2 A7 Y" f- d8 S; c3 z
The voltage shall then be linearly decreased to 1,5 times UPD (± 5 %) and held for a maximum time of 15 s, during which the partial discharge is measured' t; [! V9 v& G9 z; y) O
The test shall be considered to have been successfully passed if the partial discharge is less than 10 pC during the measurement period
: v* s _$ y! ?* e. ?4 C) ]8 Q0 y, l0 a4 ]
至于测试设备,网上一搜索就有了。
- B9 c2 J( b9 U J5 q) | |
|