|
47 Surface Marking of AWM# X- r# A6 y3 Q8 n
47.1 Surface marking is not required for appliance wiring material.& ]# Q# I, ]; k L: O& Q: z
47.2 When surface marking referencing ²AWM² is used, the marking shall contain the following elements:
h7 q9 L- ~" Z. K3 s9 o# W. Pa) Wire/cable designation: ²AWM.²
+ v; Z f6 ^" e pb) Name of the organization responsible for the AWM, trade name, other applicable mark, or
0 H# y/ R! Q) A+ s+ L, sfile number. When the organization responsible for the AWM produces AWM in more than one
( `3 o9 m( h( _! A2 ulocation, an additional distinctive marking shall be provided that identifies the specific
9 i2 O# s" W. | ~" X0 qmanufacturing location of the AWM.
; R( N2 B6 x3 zOther markings such as wire size, number of conductors, and similar data, are determined to be in3 L( s" `" I: c8 W
compliance with this requirement when they are not confusing or misleading.; S8 _) c1 o+ q& V
47.3 For a cable that contains a conductive polymeric shield, the jacket or marker tape shall be marked6 n P+ p9 D; R. ~3 _0 z6 g
²Conductive Shield,² ²Contains Polymeric Conductive Shield,² or equivalent. |
|