|
Background: OSM 2012 found it useful to have a similar decision for EN 60065 as the decision 01/8 for EN 60950-1. It has lately been questioned by the chairman of IEC TC108/MT1 that the decision 12/2 may amend EN 60065. Thus, we are proposing a revision of 12/2. Ref. OSM/EE – 2007 Item No.7.1 (enclosed):
" l( Y6 \; t4 c+ Q/ v8 H; ?“OSM decision 01/8 requires markings on the product (e.g. "Use only power supplies listed in the user manual / user instruction." or “For applicable power supplies see user instruction”). Furthermore such sentences shall be in the languages acceptable to the country where the product will be used.7 U( [/ s2 G6 l
We cannot assume that all people speak or understand English and therefore it is necessary to put nearly all languages of such relevant safety instructions on the product., @1 z" S) J8 e" R" y: J
That cannot be a solution because many products are too small!”
; t% a( K7 m, y/ SOSM/EE-2007 agreed to use instead of such instructions (sentences) on the product, international accepted symbols like these both marks (ISO 7000-0434 and ISO 7000-1641):
6 N- C1 R1 W$ c& C* {Later it was confirmed by TC108/MT1 that the book only can be used as an alternative. See explanatory notes below. Based on this it is proposed to revise decision 12/2 as amended with red text under the decision below.4 U9 F, O8 J4 e( @+ w. g
In case safety of an end apparatus relies upon the power supply for general use (adaptor) to EN 60065 apparatus, the use of the specific adaptor needs to be controlled. X" y+ J' d+ V7 p# C
The safety issues may relate to a reliable insulation, single fault conditions, heating etc.
8 W5 T0 ~. s; ~Extract of 5.4 Instructions:' z$ g: C, C% P' E" }" L* k
When information with regard to safety is required according to this standard, this information2 O$ _3 _! ]1 [ _
shall be given in an instruction for installation or use and supplied with the apparatus. …
, R4 b0 t' `. `5 M; xIt would be useful to have a similar Decision for 60065 as the Dec 01/8 to EN 60950-1.
" F! ?( f& C* EDec 01/8 is enclosed for convenience.
$ |& q. u( R" n9 t. w$ Y
5 k4 u! _& c8 \; g ?6 C9 @Decision: This decision replaces 12/2 with the amended text in red:
. W6 O- `1 e% b' I6 RWhen safety of an apparatus relies upon the power supply (adaptor) using a non-special connector for the a.c./d.c. input, the apparatus must have a marking stating the following: "Use only power supplies listed in the user instructions"" o/ e: I- r7 z& N
or) n0 m% ]1 B. O
"For applicable power supplies see user instructions". This statement shall also be in the user-instructions.9 t& @9 d% F( m6 V4 R) Q3 l
The user instructions must then have a listing of manufacturers and models of the relevant power supplies. As an alternative to the text on the product, it is acceptable to use both the symbols ISO 7000-0434 and ISO 7000-1641. The book alone is also sufficient (ISO 7000-1641).3 T5 G4 j5 F% b
4 o+ N% W, g6 j |
|