DSH 636 Resistance to heat and fire

小米

广东安规检测
有限公司提供：

小型摆管淋雨试验机

IPX5X6X7喷水试验机

1000L恒温恒湿箱

各种试验指现货

可程式恒温恒湿试验箱

水平垂直燃烧机

自动卷线器试验机

耐划痕试验机

各种灯头量规现货

灼热丝试验机现货

GB1002插头量规

IPX1-X7淋雨现货

IEC61347/UL935镇流器热试验箱

灯具防风罩

IK冲击试验机

UL498插头插座量规

VDE0620插头插座量规

稳定性试验台

家电温升测试角

针焰试验机现货

热电偶焊机现货

家电125mm试验指

E12灯头量规

无绳壶无绳电熨斗插拔寿命试验机

IEC60335试验指甲

DSH 636 2 @& u5 n& \$ f+ M9 f  f

Resistance to heat and fire 2 `$ G, v! _. N4 s: s

30.2.2 and 30.2.3 - @6 H  V1 W) }) O( @

60335-1(ed.4) 3 o4 S: C/ x5 [7 m

+ {2 Z, U0 o) L1 v8 |: }$ l& }/ CQuestion:
In the photographs included below, a construction is shown with material not resistant to the glow wire test at 750ºC/850ºC marked PP and a terminal block mounted on 3 pins moulded on the material. In order to separate the connection area from the plastic part PP, a piece of a different material has been interposed. The pins fixing the terminal block are still made of material PP and are within a distance of less than 3 mm. Should material PP in this construction be tested with glow wire test at 750ºC/850ºC?
Decision:
4 g4 S. r+ D& a2 c# BThe material shall be tested if it is less 3 mm from the connection. The 3 mm distance has to be measured from the point of connection between the wire and the screw inside the terminal and not from other terminal part.

8 U6 |4 F- O! z8 @) _
/ N+ x' R+ w7 u7 S; b2 M