coated printed board是怎么定义的？

foleyzheng

广东安规检测
有限公司提供：

小型摆管淋雨试验机

IPX5X6X7喷水试验机

1000L恒温恒湿箱

各种试验指现货

可程式恒温恒湿试验箱

水平垂直燃烧机

自动卷线器试验机

耐划痕试验机

各种灯头量规现货

灼热丝试验机现货

GB1002插头量规

IPX1-X7淋雨现货

IEC61347/UL935镇流器热试验箱

灯具防风罩

IK冲击试验机

UL498插头插座量规

VDE0620插头插座量规

稳定性试验台

家电温升测试角

针焰试验机现货

热电偶焊机现货

家电125mm试验指

E12灯头量规

无绳壶无绳电熨斗插拔寿命试验机

IEC60335试验指甲

coated printed board是指PCB板上面着附有其它的绝缘材料的意思吗？比如在印制板上喷三防漆。刚做出来的板不能叫Coated printed board?  因为PCB指的是Printing Circuit Board.

Andy.Yang

That means PCB is additionally coated, and normally this coating material is used to strengthen the PCB insulation characteristic or decrease the pollution degree of the PCB...

Andy.Yang

For detailed description:
" `2 H: ~$ U# \6 C. W# J* }1 U( R1. When the spacing( clearance and creepage) can not comply with the related standards' requirement, at this time , you can coat the PCB and then the coating can be regarded as the insulating material which replaces the spacing requirements. But pls pay attention that not all coating can be regarded as the insulating material, it must be evaluated by doing some additional tests, such as the HWI, CTI and some flammability tests.
2. When the actual pollution degree is 3, then use some coating on the PCB and at this time the pollution degree can be decreased to 2, but it also needs to be evaluated about the effectiveness of the coating material.
Finally, I'm sorry that I can not tell you whether you mentioned 三防漆 can be the qualified coating material, cause I don't know this materials characteristics, maybe there are some other experienced guys who can tell you about this issue...

mooner

一般的三防漆是不能作为Coating的。

ok_hmh

引用第2楼Andy.Yang于2010-04-22 15:16发表的  :
For detailed description:
' D# Y6 h4 m( E6 z' j1. When the spacing( clearance and creepage) can not comply with the related standards' requirement, at this time , you can coat the PCB and then the coating can be regarded as the insulating material which replaces the spacing requirements. But pls pay attention that not all coating can be regarded as the insulating material, it must be evaluated by doing some additional tests, such as the HWI, CTI and some flammability tests.
6 c3 G/ c( r/ ^) i/ E# }. e2. When the actual pollution degree is 3, then use some coating on the PCB and at this time the pollution degree can be decreased to 2, but it also needs to be evaluated about the effectiveness of the coating material.
Finally, I'm sorry that I can not tell you whether you mentioned 三防漆 can be the qualified coating material, cause I don't know this materials characteristics, maybe there are some other experienced guys who can tell you about this issue...

Can you tell what material can meet the demand?