DSH 372 Temperature for ball pressure test

小米

广东安规检测
有限公司提供：

小型摆管淋雨试验机

IPX5X6X7喷水试验机

1000L恒温恒湿箱

各种试验指现货

可程式恒温恒湿试验箱

水平垂直燃烧机

自动卷线器试验机

耐划痕试验机

各种灯头量规现货

灼热丝试验机现货

GB1002插头量规

IPX1-X7淋雨现货

IEC61347/UL935镇流器热试验箱

灯具防风罩

IK冲击试验机

UL498插头插座量规

VDE0620插头插座量规

稳定性试验台

家电温升测试角

针焰试验机现货

热电偶焊机现货

家电125mm试验指

E12灯头量规

无绳壶无绳电熨斗插拔寿命试验机

IEC60335试验指甲

DSH 372

Temperature for ball pressure test

-

Generality   U. s$ y4 z, Y% b6 T$ ~4 ?

Question:
Plastic material used for e.g. insulation or enclosure must be subjected to ball pressure test. The temperature rise of the heating cabinet (where the test has to be conducted) is specified in most standards as e.g. 75°C, 125°C or (40K + the maximum temperature rise determined during the heating test in normal use)°C . The question now is: Where is the temperature rise to be measured? Is it the hottest spot of the material? Is it inside the enclosure? Or is it on the accessible surface of the material?
Decision :
+ |7 u. b) Y! `& K' H1- The temperature should always be measured at the hottest accessible spot, which is usually on the inside of the enclosure.
: c7 f  x" T. ?* s2- The individual product standard should take precedence when determining where to measure the hottest spot. The enquiry identified a number of standards which vary in product types and require different considerations.
3- The 40K mentioned in the enquiry decision is not actually the safety margin between measurements inside and outside but a safety margin above normal operating conditions in order to anticipate abnormal conditions.
! m- M7 R5 {" e! {

9 C# ^/ F8 m# q2 }0 I# O1 x1 @5 o% B