|
本帖最后由 清水白菜 于 2012-9-25 13:58 编辑
# r# Z& r/ V3 e8 e* K; x }7 R6 K+ q' B. t2 `
In addition, double and reinforced insulation shall withstand the partial discharge test according to 7.5.3, if the recurring peak working voltage across the insulation is greater than 700 V and the voltage stress on the insulation is greater than 1 kV/mm.
5 G3 t0 D" a- q1 eCompliance is shown by impulse withstand voltage test according to 7.5.1 and the a.c. or d.c. voltage test according to 7.5.2, and partial discharge testing according to 7.5.3 if applicable.
; y( ^" }. ?/ ?& i3 o" b# U, {2 A5 Q; s, V3 u
Starting from a voltage below the rated discharge voltage UPD a, the voltage shall be linearly increased to 1,875 times UPD and held for a maximum time of 5 s
- R* P7 h6 a9 q& N% B! j0 t* T; Y& X! k+ vThe voltage shall then be linearly decreased to 1,5 times UPD (± 5 %) and held for a maximum time of 15 s, during which the partial discharge is measured$ ]' i, V$ B/ s8 s2 Z t/ a. F
The test shall be considered to have been successfully passed if the partial discharge is less than 10 pC during the measurement period
9 e( ]. W/ T% B' B+ F, s, T1 [
' w+ s( S9 Y2 x# t; l至于测试设备,网上一搜索就有了。6 h$ N! ^! j6 w) u
|
|