|
| DSH 641
0 N% B9 N/ P. j7 I/ e# V; V. v, I) i5 o2 Y" s" E
/ g" w; D1 X. @- c
| Mechanical strength
+ y+ h+ g# O5 L. @; I2 F( K& W | 21.1018 Z" M" j1 k8 l* [% p. q
| 60335-2-80(ed.2)
" A+ [9 v$ f9 i% [ | & Y; b o$ G+ @. A7 J; ]
Question:
& }: F/ g7 Q7 y$ ^How should the test of sub-clause 21.101 of IEC/EN 60335-2-80 be performed?: S3 N. i% h e5 A
Decision:
. w6 n9 S1 s! q0 i3 d) U: JThe standard does not require use of the test finger for the pull and push test. It is agreed that the intention of this test is to check the mechanical resistance of the grid wires and not to check the introduction of the finger through the grid gap, that is covered by the test of 20.2 of IEC 60335-1.
( D7 I, B( n) H6 p; H4 U+ S- GExplanatory notes:5 [/ K% M, _3 G1 Y0 A, k
The same decision (n.386) is present in the OSM/HA decision list
% }% i6 B% [0 P+ c% KSee also the decision taken by TC 61 in Penang on document 61/3368/DC5 q E/ i. h# ~& i
7 B. q2 e& O; t" v9 ]- P2 c
( R% C M% `/ W# Q5 s3 v |
本帖子中包含更多资源
您需要 登录 才可以下载或查看,没有帐号?注册安规
x
|