标题: 美规和加拿大插头--请教 [打印本页] 作者: 豆浆油条 时间: 2010-3-5 13:33 标题: 美规和加拿大插头--请教 美规插头的标准是UL1310?加拿大的插头标准是什么?两者的差异大不大? 作者: jeremyho88 时间: 2010-3-5 13:44
插头是UL817、498，根本不是1310作者: edmond_wang 时间: 2010-3-5 14:43
对啊，美规插头是UL817,怎么出来个 1310 ？作者: 豆浆油条 时间: 2010-3-5 15:44
加拿大的标准是哪个?作者: 豆浆油条 时间: 2010-3-5 15:46
1310也是有关插头的啊,它跟UL817有什么联系吗?作者: Andy.Yang 时间: 2010-3-5 17:02
I can tell you that UL817 is for power supply cords, including the attachment plugs and the flexible cords,so that is why for the UL certification of power supply cords, there are always two UL files, one is for the whole supply cords, the other is SP file, only for the attachment plugs,but UL1310 is only for the attachment plugs, so they are different. For CSA you can reference C22.2 No.49-06作者: Andy.Yang 时间: 2010-3-5 17:05
And for FUS inspection, UL auditor always verify the whole power supply's test items, such as the strain relief, dielectric resistance,and etc, but for the attachment plugs, UL auditor will select another samples without the flexible cords and send them to UL office for testing, so the test items are also different.作者: Andy.Yang 时间: 2010-3-5 17:10
If you wanna know more detailed information, you can check your company's UL file, there is a description that which standards are used. Reading these two files step by step and item by item, you will learn more.; O: I; W! e/ R
Normally, in the whole power supply's UL file(L file), UL817 will be referenced, and there is also an UL FUII for your information, and in the SP file(R file), there is some description about the component's material information, and some test introduction.作者: hehuwhu 时间: 2010-3-9 22:28
插脚到塑胶保护体的边缘要求一样吗？美国的要求是大于5.1mm，加拿大呢？作者: hehuwhu 时间: 2010-3-9 23:18 标题: 加拿大插头标准——求助（急） 加拿大插头，插脚到塑胶部分边缘的距离要求是多少？非常紧急，希望大家能够指点指点，不胜感激。。作者: jeremyho88 时间: 2010-3-9 23:37
根UL一样。其实只是规定了外形作者: Andy.Yang 时间: 2010-3-18 12:40
Studing...