标题: EN71-1:2005 Amended by A6:2008 [打印本页] 作者: hung 时间: 2009-2-14 09:40 标题: EN71-1:2005 Amended by A6:2008 EN71-1:2005 was amended recently by amendment A6:2008. The new amendments have( l; E a9 A% l" P
specified new requirements and new test methods for certain toys. Some of the affected clause+ N ~, t* U" ^" D/ u ^$ M+ u& z
requirements are summarized below for information. + s9 L- b+ K+ s& z4.8 Points and metallic wires- F3 Z- M; w7 `7 b+ q# {( a2 C
New requirement is added for metallic wires that are not designed to be bent but are likely + I3 h- E7 q. r- y4 Xto be bent accidentally or occasionally e.g. antennas on toys. It shall not break and/ M |( x9 s" @) ?9 S
produce hazardous sharp points, or protrude through the toy cover, when tested by the7 ~& |$ q; _7 j5 ]$ q1 W
flexibility test (8.13.3) for one cycle. % {! c% f; L* e+ f4.21 Toys containing a non-electrical heat source ! ~0 \$ r5 \+ v7 r8 TRequirements for temperature rises are defined for toy containing non-electrical heat ' F2 F) G- U( T& w q0 Rsource. Requirements for toys containing an electrical heat source should follow the! t* `. T. P' w' C( J& v1 X
electric toy safety standard EN62115:2005. s- T$ \3 I0 _
4.22 Small balls % @; R( Z7 k' dBall is newly defined as any spherical, ovoid, or ellipsoidal7 ]4 I: z) i: q, n
object, usually but not always, intended to be thrown, hit,7 k% U/ V4 I+ N$ R
kicked, rolled, dropped, bounced or any multisided object ( q, G# g) x3 B5 q2 Cformed by at least 48 connecting planes into a generally - X6 y; n2 G' _1 T: Fspherical, ovoid or ellipsoidal shape.0 @& h7 [2 Q* u% \8 P
New requirement is added for freely suspended ball from a $ X6 h Z+ y: u l3 N+ ?- stoy by attachment of a string, elastic cord or similar such that ; l. G: |8 g" T! \7 m1 @4 z; Wit shall not pass through the test template E to a distance (A)& }" C7 @0 ?. I, d, I7 J+ q* x: i4 P
greater than 30mm when tested according to 8.32.2. 5 g+ U( s1 s7 j k. b" N( t. `5.12 Hemispheric-shaped toys ( k: J- P' V+ P* Q y2 zObjects intended for drinking e.g. tea set cups is subjected to the requirements due to the0 q, m& P/ D$ F
European Commission’s decision 2007/184/EC of March 23, 2007. $ y; n8 d( R1 N; F3 g5 n8.6 Tip over test$ o, s7 k+ n9 q6 D3 Z
Large and bulky toys shall be pushed horizontally by applying a force ≤ 120N at 1500mm8 ]) d' N/ X& D1 L9 j
from the ground or at the top edge of the toy for toys less than 1500mm height.