安规网

标题: 230V户外灯串的插头线径要多大,有何规定? [打印本页]

作者: legang    时间: 2007-12-18 09:11
标题: 230V户外灯串的插头线径要多大,有何规定?
多谢各位回复!3 R; u! D# z$ k
请教:230V户外灯串的插头线径要多大,有何规定?
' M; f. s- J, k     1.有人说现在到欧盟的230V户外灯串的插头线径必须1平方以上,是有这样的规定吗?% q2 f0 ]. F( `0 b4 U) O+ R% z2 ^0 B
      2.但也有人说是:到欧盟的230V户外灯串的插头线径求0.75平方以上就可以了,是这样的吗?
3 P# J- n, _6 ^- ?8 |! P" D      3.但我公司今年换证的GS证书上说是0.75平方以上的插头线是,那就是可以用0.75平方以上的电线了,是这样的吗?
作者: af204    时间: 2007-12-18 09:50
可以看60598-2-20:A2:2002 部分,有规定的
作者: legang    时间: 2007-12-18 10:34
英文看不明白,最好能发个有中文的吗?
作者: af204    时间: 2007-12-18 11:02
没有中文的!
作者: legang    时间: 2007-12-18 14:56
我英文太差了,楼上大哥能说说标准中是如何说的?
作者: schwarzwald    时间: 2007-12-18 15:53
要看灯串的具体情况而定。
' h# H8 I. Q( |60598-2-20 的20.10.1章节:
5 {1 f' G7 l, a: v: J0 MThe nominal cross-sectional area of the conductors shall be not less than one of the following
8 D( v6 \6 ^" U$ E& X/ l. ovalues:5 t" F. l1 ?4 V+ T
a) 0,5 mm2 for ordinary lighting chains with E5 or E10 lampholders or other small
% @1 m8 m' u. n4 U2 Zlampholders.: [$ p5 U: ?9 L7 N: \% b
b) 0,75 mm2 for other lighting chains with E5 or E10 lampholders or other small lampholders,0 P7 O0 E" v: n& J
and for lighting chains with E14, E27, B15 or B22 lampholders and fitted with seriesconnected
- P0 ^  Z- H" @% s; |' P/ a% W; y7 f, Hlamps.
; u2 z) D9 q! t; v+ u7 l; x5 C) Ec) 1,5 mm2 for lighting chains with E14, E27, B15 or B22 lampholders and fitted with parallel1 v2 n0 u' @9 t; r2 e) T9 k" q+ `- M
connected lamps.
( z- s( y+ t$ W" HIf the maximum rated wattage of class III lighting chains and parts of chains supplied by
2 C( K6 n9 @1 g7 n' N- WSELV is less than 50 W then the conductors of the internal and external cables may have a
* @% f+ e2 E. c1 \cross-sectional area of 0,4 mm2 or less provided that the current-carrying capacity and the
- n- F7 g, ~& q' Kmechanical properties are adequate. If the maximum rated wattage exceeds 50 W, the cables
+ U% F$ ~/ V8 f3 Dshall comply with 60227 IEC 42 (see asterisk above). If the wattage is less than 50 W the2 C  w) K. w0 w' u9 a* T
insulation of the cables shall comply with the requirements of 5.3.1 of IEC 60598-1." [* Z8 ~: u% V  `7 q
For sealed chains, the internal conductors may have a cross-sectional area of 0,4 mm2 or less9 ~# a$ G' m* l' y( R. B. b
provided the current-carrying capacity and the mechanical properties are adequate. In addition,
/ j* g0 C8 T" ~9 x) z) Sconductors without insulation are accepted provided adequate precautions have been taken to8 d! d. A8 [5 [
ensure maintenance of the minimum creepage distances and clearances and compliance with1 r% C, y) Z! `3 u
the requirements of 5.3.1 of IEC 60598-1.
' R0 e! G: k3 n7 I8 A, B3 jCompliance is checked by inspection, measurement
作者: af204    时间: 2007-12-18 16:33
请看:) a  a& A' X3 T0 t1 K
IS 03 Interpretation of subclause 20.10.1
  z& A3 L# `$ O2 @+ L5 yIEC 60598-2-20: 1996 Second edition! j* E% n. ~2 u- H, p4 `
Luminaires – Part 2-20: Particular requirements – Lighting chains
4 E6 I) ]$ \8 @7 Q( x- y: Y( m5 P0 c3 ~
July 2003 ICS 29.140.40
$ K4 T4 l! V( b. f: t: \! @2 ]1 K5 e7 y8 e4 s
The nominal cross-sectional area of the conductors shall not be less than the following% V* |. h$ n# @
values:
: T" [4 e$ P: O. z$ ^( R9 Ha) 0,5 mm² for class II lighting chains with E5 or E10 lampholders or other small
2 x6 B# X' f8 clampholders;
' s  W' Q- ?2 E9 k' A4 O9 h( cb) 0,75 mm² for class II lighting chains with E14, E27, B15 or B22 lampholders and fitted
6 F  Y/ _. j. k# Bwith series connected lamps;7 F, a: X+ Y3 N
c) 1,5 mm² for class II lighting chains with E14, E27, B15 or B22 lampholders and fitted
% `: B/ r5 Q- Y. L3 Z( p' g+ zwith parallel connected lamps;; j- ]" u2 F: P/ r+ m( ]
d) 0,5 mm² for class III chains and parts of chains supplied by SELV and with a* _! t! L) m; v( `. }
maximum rated wattage exceeding 50 W;
: P5 K) n; G6 E, E/ i9 U* B. O7 \$ s( Ne) 0,4 mm² for class III chains and parts of chains supplied by SELV and with a
* W' C( ]* ^4 f* f+ b% y2 T  i( Hmaximum rated wattage not exceeding 50 W;& J% S5 Q) J" S% t4 a
f) 1 mm² for the cable between the plug and a sealed chain without joints;/ y0 a  d) v. v# z- c& G
g) 1,5 mm² for the cable between the plug and a sealed chain with joints.
作者: legang    时间: 2007-12-20 10:13
唉,我中文太差了,看不明白,能解释下吗?




欢迎光临 安规网 (http://bbs2.angui.org/) Powered by Discuz! X3.2