Marking of Wiring Terminals4 A5 R, B: z8 |& w5 {' ^5 @4 t
1.7.7 n* |, E! y* b& \2 d: f
60950(ed.2) & 60950(ed.3)% j9 @9 M, F8 T R) V/ \4 R( V
4 p& n9 `0 l! @7 P% h* LStandard:" r A: ^) n" |/ \. c) _
IEC60950, 2nd and 3rd edition' z3 Y m" S/ L _4 D; n
Sub clause: : S+ ~9 }1 o0 x4 o1.7.7 5 O, t1 j* i$ q- j5 r1 S. NSheet n. 383' f( k/ o7 g- A& M
Page 1 (1)# f. H. v3 j. N9 l1 W
Subject: 8 v! M s; ~, |% R qMarking of Wiring Terminals6 l" Q9 L% S- R9 }
Key words:: k. p0 e$ {: p [) R( \
-Marking6 U, C1 ?( H2 Z# ^" W! Z% x* w
-earth-symbol. E& x1 ]# b. M u1 ^, b. V3 Z
–Wiring Terminals 3 J/ t) c& j! q2 g8 [) y4 V& R& jDecision confirmed; M+ D/ ]$ D% u& b/ s
at CTL 38th meeting" M( M5 y1 v/ q% |
Question:4 Q1 W/ L( e/ t9 J. o; M
Is this requirement applicable to products provided with a mains inlet? If yes, is the symbol 3 @& K5 w1 N9 K2 c8 ]IEC 417 No. 5019, then, required at the location where the earthing conductor (coming from * a, h2 q5 h7 t: z& G- Zthe inlet) is terminated? " X! b# [" R7 U+ t- X0 XDecision:+ I t9 z: W$ |$ }- |
The symbol is not required in the above mentioned case 1 V/ d: _1 z/ c" F4 O 6 a+ V0 a$ h' q6 p6 b y[attach]77176[/attach] . ~; f: S& o% \& v2 E0 {/ M
DSH 383