安规网

标题: DSH 486 Components [打印本页]
作者: 小米    时间: 2012-9-11 14:31
标题: DSH 486 Components
DSH 486! c/ @8 `/ R& D: v

: Z; w4 T2 V: E! G+ ^6 M( Z7 A. U4 H( p) M' Z
Components
) v2 Q3 P2 g0 t! X$ ^+ h; D, |		24.5, 25.223 i0 _# q$ Q( _8 b1 }/ V& B5 K
60335-1(ed.3)  ^7 _& o, \" J- u
: t0 B( ?4 J9 v, y* ]: y
Standard: IEC 60335-1:1991, 3rd Ed.
$ U1 l0 w$ F. ?4 xSub clause: 24.5, 25.227 {% _- [9 t  i
Sheet No. DSH-4868 s, ~$ B" x* s# |/ d5 y
Subject: Components
; R7 t: O9 f9 _& ^: O' yKey words: - appliance inlets for intermediate connection - socket-outlets not standardised
1 Z0 \! V1 {# uDecision taken at the 40th CTL meeting 2003
0 F. b8 R$ w0 K7 e  s0 a1 SQuestion:
/ p% S/ S; {! }  v- o- s% ZWhat are the requirements applicable to appliance inlets, intermediate connection devices; `$ m( P" K3 S( n* i- W
and socket-outlets not standardised in IEC 60320?5 p. C: V) G# p$ W
Rationale:$ _" I4 k8 p- o% |
See question.
5 ?0 A' e7 y! K3 cDecision:
8 N  y. f' F6 y+ m1) Compliance is required with IEC 60320 except for the standard sheets. The creepage0 r' P. u7 m5 C3 Y6 [/ q: h
distances and clearances between live parts and the front surface shall be at least 5.7 mm.
6 |4 X' ~+ t- _4 JThe test pin is not applied. The appliance inlet is with regard to clause 8 considered as for$ L! t4 ^4 Y& l! H+ c/ L; f+ @
socket -outlets.; g2 c9 R0 i0 ?8 _! Z, y% ~( y- t7 a
2) Cord-sets connected to non-standardized appliance inlets shall be delivered with the
- ]: V6 ]7 \9 g- o! {appliance.1 J' Q. I8 b5 w: Y9 E$ |' b( R, {
3) Item 1) does not apply for appliances of which, after installation, the connection devices
, X: w( L6 ^1 ocannot be touched.
8 |2 L" ^- D3 H# m5 J6 [2 O( G* |/ k9 q1 q0 L- f- f2 ?
[attach]75839[/attach]4 ~" Z" m+ G/ E: W( B
# ]1 L1 y3 z$ C8 `7 M# ]; D

2 L$ t4 ~0 M  m# ]! i, [6 h$ m4 s8 @3 e6 U
, }9 l4 F; A$ Z( X( K7 K) n




欢迎光临 安规网 (http://bbs2.angui.org/) Powered by Discuz! X3.2